Sky Prog Programmer

Code

Description, possible reasons

F01

Short-circuit triac of drive motor control

F02

The tachogenerator does not generate a signal about the rotation of the drive motor (the sensor circuit may be in the clipping or short-circuited).

Другой причиной этой ошибки является блокировка приводного двигателя.

F03

Temperature sensor circuit (NTC) in the open or short circuit. The port of the NTC control panel is defective.

F04

The level sensor (pressostat) simultaneously generates the signals "EMPTY TANK" and "OVERFLOW"

F05

After the discharge program is executed, the level sensor does not form the "BLANK TANK" signal (the drain pump is not working, the drainage path is blocked, the level sensor is faulty)

F06

The program code is not recognized (error of buttons on the front panel)

F07

There is no heating

F08

"Clogging" the contact group of the heater relay. Defective heater or its wiring (leakage to the housing)

F09

Error (crash) of contents of non-volatile EEPROM memory

F10

Simultaneous absence of signals from the level sensor FULL TANK and EMPTY TANK

F11

There is no supply voltage at the drain pump (pump supply circuit in the open circuit)

F12

There is no communication between the display module and the electronic controller

F13

Drying temperature sensor circuit in the open or short circuit

F14

The drying heater does not work (only for washing machines with drying)

F15

Faulty drying heater relay (only for washing machines with drying)

F16

Blocked drum (only in washing with top loading)

F17

The door lock is not energized or the door is open

F18

Communication error between the controller ICs and the DSP (Asynchronous Drive Motor Control Processor) on the main board