Sky Prog Programmer

Code

Description, possible reasons

00 

(Continuously flashing) The power board is defective, the power board is not programmed. 

01 

The system has detected a malfunction of the door lock device CM ( the door is not locked , the indicators do not light up )

02 

The signal problems in the system loading of water ( the water level reaches or exceeds the nominal ) and fault valve clogged filter 

0З 

The signal problems in the drain water (draining missing or timed drain )

04 

The signal problems in the system loading of water ( the water level within the set limits ) 

05 

The system indicates problems with temperature sensor – no hot water , washing stops

06 

EEPROM Неисправно силовая плата и / или подключения. 

07 

Defective door lock (locked closed) and / or connection.

08 

Defective tachogenerator (In short circuit or wire broken).
Tacho value for the engine Ceset: 42 Ом
Tacho value for the engine Selni: 90 Ом
Tacho value for the engine Sole: 184 Ом 

09 

The power board is defective - damage to the motor triac and / or connection.

10 

(Top loading) The drum positioning system is faulty.
(Front loading) There is no communication between the electronic cards.

11 

In the open or short circuit the dryer temperature sensor (NTC) and / or the electronic board and / or connections.

12 

No air heating during drying. Faulty dryer NTC and / or dryer heating element and / or connecting.

13 

There is no connection between the power board and the display board.

14 

There is no water heating: the temperature sensor (NTC) is faulty and / or the heating element and / or the wiring is faulty.

15 

The power board is not programmed correctly. 

16 

The heating element in the short circuit or its insulation is faulty. 

17 

There is no signal from the tachogenerator.

18 

Defective power board or connections, wrong frequency of the power supply.